The maintenance of mask equipment after purchase is very important. The main maintenance is well done, and the equipment runs smoothly. The masks produced meet the standards, and this detail has a very large impact. How do we check the common problems and solutions:
Folding mask machine
Masks are worn on our faces, and some even need to be used in the operating room. Therefore, the production of masks must be cleaned by a mask machine every day. You can arrange for personnel to clean the work surface of the equipment and the plate holding the mask after the power is off every day at the end of work. Be careful not to use water or oil. You can use other non-toxic and volatile cleaning fluids such as alcohol. Folding mask machine manufacturer
2. Ultrasonic system:
Check whether the ultrasonic system is clean, especially the ultrasonic electric box, ultrasonic transducer, and welding head need to be cleaned monotonously without water, and whether the connecting line is strong. Often check the degree of wear of the ultrasonic welding head (die). Check carefully whether the pointers of the voltmeter and ammeter on the ultrasonic electric box are normal.
3. Transmission system:
The transmission system includes motors, gears, reducers, sprockets, chains, conveyor belts and other components. The protection of the mask machine needs to check whether there is dust on the surface of the motor that affects heat dissipation, and whether the gears and sprockets are oiled or have attachments. Is the tightness of the chain suitable? Is there any foreign matter? Is the connecting screw of each transmission part loose? Is the lubricating oil of the reducer sufficient? Usually, the lubricating oil needs to be replaced once every 1000 hours to 1500 hours. Folding mask machine manufacturers
4. Electrical system:
Check whether the circuit connector of the mask machine is loose, whether the main power cord, branch signal line, etc. are worn out? Aging? Loose? Is the inside of the electric box clean and monotonous? Is the exhaust fan working normally?
Five: Pneumatic system:
Is there water in the air filter check? Check whether the air pipe is leaking? Whether the cylinder is leaking? Is the cylinder magnetic sensor orientation and working properly.
Add: Henan Communication Industry Area, Jingbei 3rd Road, Zhengzhou, Henan, China